The cutting machine is composed of a cutting knife set, a conveying table, a positioning guide and a frame. The cutting machine is made of iron suitable for dry cutting. Wet cutting all kinds of stone, building materials, ceramic tiles, granite, marble, cement board, red brick, refractory brick, etc. are necessary tools for home decoration.

First, before work

1. Wear overalls and wear eye protection. The female worker will put the hair on the work cap.

2. The power knife switch, the tightness of the saw blade, the blade guard or the safety baffle should be inspected in detail, the console must be stable, and there should be sufficient illumination at night.

3. Turn on the main switch and test the airwheel for a few laps. It is only allowed to start after the safety is confirmed.

Second, at work

1. Do not wear gloves. Wear a mask or face shield if it can cause dust during operation.

2. Do not attempt to cut small workpieces that are not clamped.

3. This cutting machine only allows cutting profiles.

4. Do not perform strong sawing operation, and make the motor reach full speed before cutting.

5. No one is allowed to stand behind the saw.

6. Do not lean over or bypass the saw machine. Do not loosen any hand or lift the arm from the saw or workpiece when the saw blade is not stopped.

7. Do not operate the guard when it is not in place. Do not place your hand within 15 cm of the saw blade.

8. Always turn off the power before servicing or replacing the accessories, and wait for the saw blade to stop completely.

9. If there is abnormal sound, stop checking immediately.

Third, after work

1. Turn off the main power

2. Clean and organize the workbench and venue

Four, In the event of personal or equipment accidents, the site should be kept and reported to the relevant department.